Speargun Muzzle Adapters for Rubbers
- 14mm-1 Male Thread ( Class 6g )
- Package qty 2 [not much good having just one of them]
- This part is more common than the 16mm size which is typically found on older guns.
- Measure the holes on your muzzle before ordering this part
- Made from 6061 Aluminum with Hardcoat Sulfuric Acid Anodize finish, TYPE III class 2 (Black)
- (~.25 oz per part)
How to Measure:
ADAPTER Thread SIZE NOTES and Comments:
There are lots of mis-information on thread sizes vs rubber tubing OD's out there in Forums and Dive sites. This Part is made to be a True 14mm-1mm Thread Class 6g.
The Female threaded hole on your muzzle should measure around ~13mm (e.g. a 12.9 - 14.1mm solid Pin should just fit inside the internal threads).
If your threaded muzzle hole measures ~15mm, then you most likely need a 16mm-1mm Adapter, and NOT this part., See other Adapter 16mm-1, B3017-1.
I've seen Muzzles and band call out for "16mm threading". This jargon is totally misleading and confusing. I purchased one of these muzzle parts to verify what that term meant and it is a 14mm-1 thread that I measured.
My only thought on this confusing language is from the Rubber Tubing OD size of 16mm, then it is assumed to be "16mm threading". Yes, I Rolled my Eyes too. |o)